Table of Contents
Advertisement
Installation Guide Linear Motors
13 UK Declaration of Conformity UKCA-Marking
NTI AG / LinMot ®
Bodenaeckerstrasse 2
8957 Spreitenbach
Switzerland
Tel.:
+41 (0)56 419 91 91
Fax:
+41 (0)56 419 91 92
declares under sole responsibility the compliance of the products:
•
Linear Motors of the Series PS10-70xxx-xx-xx
•
Linear Motors of the Series PS10-70xxx-xx-xx-D04
•
Linear Motors of the Series PS10-70xxx-xx-xx-D05
•
Linear Motors of the Series PS10-70xxx-xx-xx-D24
•
Linear Motors of the Series PS10-70xxx-xx-xx-D24S
•
Linear Motors of the Series PS10-70xxx-xx-xx-D25
•
Linear Motors of the Series PS10-70xxx-xx-xx-D25S
•
Linear Motors of the Series PS10-70xxx-xx-xx-D26
•
Linear Motors of the Series PS10-70xxx-xx-xx-D34
with the Electrical Equipment (Safety) Regulations 2016 SI 2016 No. 1101
Applied designated standards:
•
EN 61800-5-1: 2007
with the EMC Regulation S.I. 2016 No. 1091.
Applied designated standards:
•
EN 61000-6-2: 2005 (Immunity for industrial environments)
•
EN 61000-6-4: 2007 (Emission for industrial environments)
According to the EMC regulation, the listed devices are not independently operable products.
Compliance of the regulation requires the correct installation of the product, the observance of specific
installation guides and product documentation. This was tested on specific system configurations.
The safety instructions of the manuals are to be considered.
The product must be mounted and used in strict accordance with the installation instructions contained within
the installation guide, a copy of which may be obtained from NTI AG.
Company: NTI AG
Spreitenbach, 25.08.2023
Dr.-Ing. Ronald Rohner
CEO NTI AG
NTI AG / LinMot
P10-70-SSC / P10-70-SSC-Dxx
ENG
Page 43 / 44
Advertisement
Table of Contents
