Table of Contents
Advertisement
Installation Guide Linear Motors
Slider front end with ring / notch
3.3 Mounting the stator
The stator is mounted by clamping. The LinMot flange (see the section 5.2 Accessories) or a similar flange
can be used for this purpose. Most important is a broad clamping surface in order to provide good heat
dissipation. Forced air cooling can also increase the continuous force of the linear motor by up to a factor of
1.8.
The flange clamp must not deform the stator.
Make sure the torque on the clamp plate screws does not exceed the maximum value.
Type of flange
PF02-23
PF02-37
PF01-48
3.4 Mounting the payload to the slider
The load is mounted as a fixed bearing using spherical washers and conical seats (see the section « Slider
mounting kits » ).
•
To avoid shear force on slider and wear on stator, the payload has to be beared by a
linear guide.
•
Slider back end should not be used for load mounting.
Page 8 / 40
4. Checking the installed direction of slider
After the installation, the front end of the slider
is located at the opposite side of the stator from
the cable connector or cable exit.
Incorrect mounting
Small contact area prevents cooling of the linear
motor
Correct mounting
Better heat dissipation with the LinMot flange
Correct mounting
Forced air cooling with LinMot fan to increase the
continuous force rating.
P01-23 / P01-37 / P01-48
Max. torque for screws
4 Nm
8 Nm
12 Nm
ENG
NTI AG / LinMot
Advertisement
Table of Contents
