Table of Contents
Advertisement
Installation Guide Linear Motors
Slider front end:
M10 thread + cut-in
3.3 Mounting the stator
The stator is mounted by clamping. The LinMot flange (see the section 5 « Accessories ») or a similar flange
can be used for this purpose. Most important is a broad clamping surface in order to provide good heat
dissipation. Additionally, the cooling can be increased by a fan or liquid (water cooling), so that the
continuous power is significantly improved.
The flange clamp must not deform the stator.
Do not exceed max. torque of 12 Nm.
3.4 Mounting the payload to the slider
The load is mounted as a fixed bearing using spherical washers and conical seats (see the section 5).
•
To avoid shear force on slider and wear on stator, the payload has to be beared by a
linear guide.
•
Slider back end should not be used for load mounting.
Page 8 / 32
Slider back end:
M10 thread
Incorrect mounting
Small contact area prevents cooling of the linear
motor.
Correct mounting
Better heat dissipation with the LinMot flange.
Correct mounting
Forced air cooling with LinMot fan to increase the
continuous force.
P10-54 / P10-54-D24/25/25S
4. Checking the installed direction of slider
After the installation, the front end of the
slider with M 10 thread and cut-in is located
at the opposite side of the stator from the
cable exit.
ENG
NTI AG / LinMot
Advertisement
Table of Contents
