Electrical Connection; Motor Cable; Technical Data Of The Stator Cable - LinMot P01-23-HP-SSCP Installation Manual

Installation Guide Linear Motors

4 Electrical connection

4.1 Motor Cable

Do not connect or disconnect motor when there is power on the servo drive.
Use only double-shielded original LinMot cable. Cables from other sources must be
checked precisely before commissioning.
Incorrect connections can destroy the drive and stator.
The stator is connected to protective earth via the motor cable. The screw connections of
R connector must be tightened up to the stop.
Three types of cables are available for linear motors. The standard motor cable is intended
for stationary installation. The High-Flex cable (suitable for trailing chains) and the robot
cable are used for moving cable applications. The connector cable integrated in the stator is
20 cm or 150 cm (R20 or R150) long depending on the stator variant and must not be
moved.

4.1.1 Technical Data of the Stator Cable

Cable name
Cable length
Minimum bending radius for
fixed installation
Minimum bending radius
when moving
Approval
Material wire insulation
Material cable sheath
Permissible temperature
Oil resistance
Chemical resistance (to
acids, alkalis, solvents,
hydraulic fluid)
NTI AG / LinMot
PS01-23x80F-HP-SSCP-R20
PS01-23x160H-HP-SSCP-R20
KS03-04/05
200 mm
25 mm
(0.98 in)
Not suitable for applications with
moving motor cable.
UL / CSA 300V
TPE-U
PUR
very good acc. DIN VDE 0282
Part 10 + HD 22.10
good
P01-23-HP-SSCP
PS01-23x80F-HP-SSCP-R150
PS01-23x160H-HP-SSCP-R150
KS03-04/05
1500 mm
25 mm
(0.98 in)
Not suitable for applications with
moving motor cable.
UL / CSA 300V
TPE-E
-40 °C...+80 °C
very good acc. DIN VDE 0282
Part 10 + HD 22.10
ENG
PUR
good
Seite 13 / 30