Overview.and.description.of.the.auxiliary.functions - EBRO ARMATUREN EP 501 C Operating Instructions Manual

24.2. Overview and description of the auxiliary functions
ADD.FUNCTION
* The SPLTRNG auxiliary function can only be selected if P.CONTROL (process control) is not activated.
Figure 41: Overview - auxiliary functions
88
CHARACT
ENTER
CUTOFF
DIR.CMD
DIR.ACT
SPLTRNG *
X.LIMIT
X.TIME
X.CONTROL
P.CONTROL
SECURITY
SAFEPOS
SIG.ERROR
BINARY.IN
OUTPUT
CAL.USER
SET.FACTORY
SER. I / O
EXTRAS
POS.SENSOR
SERVICE
SIMULATION
EXIT
DIAGNOSE
english
Typ EP 501
Auxiliary functions
Selection of the transfer characteristic between input signal
and stroke (correction characteristic)
Sealing function for positioner
Sense of effective direction between input signal and set-
point position
Assignment of the aeration state of the actuator chamber to
the actual position
Signal split range; input signal as a % for which the valve runs
through the entire stroke range.
Limit the mechanical stroke range
Limit the control speed
Parameterization of the positioner
Parameterization of the process controller
Code protection for settings
Input the safety position
Configuration of signal level fault detection
Activation of the binary input
Configuration of outputs (option)
Calibration
Reset to factory settings
Configuration of serial interface
Adjusting the display
Setting interface remote path sensor
(available for Type EP 501 L only)
For internal use only
Simulation of set-point value, process valve, process
Diagnosis menu (option)