Table of Contents
Advertisement
Typ EP 501
PROFIBUS DP
26.3.
Changing the operating state
There are two ways of switching between the MANUAL and AUTOMATIC operating states for the PROFIBUS DP:
• Input via the keyboard on the device:
On the process level using the key function
• The operating state is transferred to the device via the bus (under PDO MODE).
In this case switching is no longer possible using the keyboard on the device.
26.4.
Safety settings if the bus fails
The position is approached which corresponds to the set-point value last transferred (default setting).
Other setting options (see chapter "28.3. BUS.COMM – Settings on Type EP 501".
26.5.
Bus status display
The bus status is indicated on the display on the device.
Display
BUS offline
is displayed approx. every
3 seconds
Table 92:
Bus status display; PROFIBUS DP
26.6.
Differences between the field bus devices and
devices without a field bus
The.following.chapters.of.these.operating.instructions.are.not.valid.for.the.devide.with..
PROFIBUS.DP.
• Section "Installation"
• Section "Start-up"
• Section "Auxiliary functions"
MANU
and
Device.status
Explanation
Device is not connected to the
bus
offline
Chapter„ "14. Electrical connection - Terminal version for cable gland"
Chapter "21.1. INPUT - Setting the input signal"
Chapter "24.2.5. SPLTRNG – Signal split range"
Chapter "24.2.15. CAL.USER – Calibration of actual value and set-point value"
- Menu option calibr.INP, calibration of the position set-point value
- Menu option calibr.SP, calibration of the process set-point value
AUTO
.
Troubleshooting
• Check bus connection
including plug assignment.
• Check operating voltage
and bus connection of the
other nodes.
english
173
Advertisement
Chapters
Table of Contents
