Diagnose - Menu For Monitoring Valves (Option) - EBRO ARMATUREN EP 501 C Operating Instructions Manual

24.2.22. DIAGNOSE – Menu for monitoring valves (option)
The optional function DIAGNOSE can be used to monitor the state of the valve. If there are deviations from the
set-point state, messages are output according to NE 107.
Example of the output of a diagnosis message:
Figure 74: Example of a diagnosis message
24.2.22.1. Activation of the DIAGNOSE menu
To ensure that the DIAGNOSE menu can be set, it must first be activated in the main menu of the setting level (MAIN)
via ADD.FUNCTION. See Chapter "24.1. Activating and deactivating auxiliary functions".
The active diagnosis is indicated on the display of the process level with a check mark symbol
"Figure 74".
24.2.22.2. The DIAGNOSE main menu
The DIAGNOSE main menu consists of the following submenus.
D I A G N O S E
>>.D.MSG.<<
CONFIG.MSG
ADD.DIAGNOSE
RESET.HISTORY
29-1
EXIT
Table 66: DIAGNOSE; main menu
The description can be found in Chapter "24.2.22.5. Description of the DIAGNOSE main menu".
130
0.0
POS
MENU CMD POS MANU
D.MSG
CONFIG.MSG
ADD.DIAGNOSE
ENTER
RESET.HISTORY
english
Status signal
Symbol for:
Diagnosis active
(Diagnosis messages) list of all diagnosis messages.
Assignment of status signals for different diagnosis messages
according to NE 107 (NE = NAMUR recommendation).
Activation of diagnosis functions by incorporation into the
DIAGNOSE main menu.
Deletion of the history entries of all diagnosis functions.
The menu is only displayed if the CLOCK function has been
selected on the process level.
Typ EP 501
Auxiliary functions
. See