Adjusting.the.display; Possible Displays Of The Process Level - EBRO ARMATUREN EP 501 C Operating Instructions Manual

Typ EP 501
Operation
16.3. Adjusting the display
The display can be individually adjusted for the operation and monitoring of the process.
• To do this, menu options can be activated for displaying the process level. POS and CMD are activated in the
as-delivered state.
• The menu options which can be displayed depend on the type.
How you can adjust the display individually to the process to be controlled is described in Chapter
"24.2.18. EXTRAS – Setting the display", page 121 ".

16.3.1. Possible displays of the process level

Possible.displays.in.AUTOMATIC.operating.state
POS
MENU
CMD/POS
CMD
MENU POS TEMP MANU
TEMP
C

MENU CMD
CMD/POS
PV
m3/min
MENU TEMP
SP
m3/min
MENU PV PV (t) INPUT
SP / PV (t)
MENU
Actual position of the valve actuator
0.0
(0 ... 100 %)
CMD MANU
• Set-point position of the valve actuator or
0.0
• Set-point position of the valve actuator after rescaling by possibly
activated split range function or correction characteristic
(0 ... 100 %)
Internal temperature in the housing of the device
0.0
( °C)
Process actual value
0.0
Only.for.Type.EP.501.C
SP MANU
Process set-point value
0.0
Right selection key
The key function depends on the set-point value default
(menu: P.CONTROL→ P.SETUP → SP-INPUT → internal/external).
INPUT
Set-point value default = internal
MANU
Set-point value default = external
Only.for.Type.EP.501.C
Graphical display of SP and PV with time axis
Only.for.Type.EP.501.C
HOLD
:
english
51