Output Signals To The Control Centre (E.g. Plc) (Required For Analogue Output And/Or Binary Output Option Only); Operating Voltage - EBRO ARMATUREN EP 501 C Operating Instructions Manual

Typ EP 501
Installation
14.2.2. Output signals to the control centre (e.g. PLC)
(required for analogue output and/or binary output option
only)
→
Connect terminals according to the model (options) of the positioner.
Terminal Configuration
83 + Binary output 1
85 + Binary output 2
31 + Analogue feedback +
32 – Analogue feedback GND
Table 11: Terminal assignment; output signals to the control centre

14.2.3. Operating voltage

Terminal Configuration
+24 V Operating voltage +
GND Operating voltage GND
Table 12: Terminal configuration; operating voltage
On.the.device.side External.circuit./.Signal.level
83 + 24 V / 0 V, NC / NO specific to
operating voltage GND (terminal GND)
85 + 24 V / 0 V, NC / NO specific to
operating voltage GND (terminal GND)
31 + + (0/4 – 20 mA or 0 – 5 / 10 V)
32 – GND Analogue feedback
On.the.device.side
+24 V
GND
completely galvanically isolated
External.circuit./.Signal.level
24 V DC ± 10%
max. residual ripple 10%
43