Basic.setting.of.the.device; Basic.setting.of.the.device - EBRO ARMATUREN EP 501 C Operating Instructions Manual

Typ EP 501
Start-Up
21. BASIC SETTING OF THE DEVICE
The following settings must be made for the basic setting of the device:
1. INPUT Selection of the input signal (see Chapter "21.1").
2. X.TUNE Automatic self-parameterization of the positioner (see Chapter "21.2")
Operating structure for the basic setting:
Process.level (values are displayed)
Press for approx. 3 s
MENU
Setting.level.
Main.menu.(MAIN)
EXIT
* required only for start-up of the process controller (see Chapter "22. Activation of the process controller")
Figure 22: MAIN – main menu, operating structure in as-delivered state
INPUT
ENTER
X.TUNE
RUN
Hold.down
as long as
countdown
(5 ...) is
running
Manual.TUNE, Manual parameterization
(not required for standard applications)
RUN X.TUNE.CONFIG
press.
M.TUNE.POS
briefly
M.TUNE.PWM
M.TUNE.AIR
Activating auxiliary functions *
ADD.FUNCTION
Configuration ENTER
Select the input signal
SELEC
4-20 mA
0-20 mA
0-10 V
EXIT
0-5 V
Automatic self-parameterization
X.TUNE
STARTED
TUNE #0
INIT
X.TUNE
READY
EXIT
ENTER
Select
parameters
EXIT
CARACT
ENTER
P.CONTROL
DIAGNOSE
english
SELEC
EXIT
EXIT
61