Table of Contents
Advertisement
TIP:
If the Welcome menu does not appear after switching on the receiver the first time, reset the
receiver to factory settings by pressing the MENU button and selecting Load Factory Setting
in the submenu Tools. (DEFAULT PIN: 1234).
5.0 QUICK GUIDE TO USING YOUR RECEIVER
We at STRONG understand that you can't wait to enjoy your digital HD cable receiver. The following quick guide will
make you familiar with the basic operation of this device. We do, however, advice you to read the full manual to get the
best performance from your receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose a channel with the pq buttons. Alternatively, you can digit the channel number with the 0~9 buttons on
the remote control or press OK in viewing mode to display the channel list. The volume can be adjusted with the t u
buttons.
6.0 OPERATION
6.1 Changing channels
Following ways are possible for changing channels with your new receiver:
Via direct access using the 0~9 buttons.
„
„
Via the channel list using OK and the PG+/PG- buttons.
„
„
Via the pq buttons.
„
„
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the 0~9 buttons on the remote control. Channel
numbers can be up to four digits long. Entering a number with less than four digits is possible. Just wait a few seconds
and your receiver will switch to the selected channel or press OK immediately after selecting the channel number.
6.1.2 Channel list
Press OK in viewing mode to display the Channel List. Use pq in the channel list to highlight your channel of choice
and press OK once to select the highlighted channel. Press OK again to leave the channel list mode. Inside the channel
list it is possible to use the PG+/PG- buttons as well in order to scroll page-wise through the list.
TIP:
Use t u to toggle between the All Channel list and favourite list(s) or press FAV in viewing
mode for a list of the available favourite lists.
6.1.3 Using the
pq
p switches to the next channel.
q switches to the previous channel.
6.2 Info Banner
While watching TV you can press the INFO button at any time to access current information about the channel and
event*. Press INFO twice for extended EPG details about the current channel. Press INFO three times for technical
details about the current channel.
* Event information is displayed when available. Availability depends on the broadcast.
6.3 Selection of audio language
Some channels support a choice of audio formats and/or languages. To select another audio stream, press AUDIO in
viewing mode. A list with available audio streams will now be displayed. Use pq to select a stream and confirm with
OK. The audio channel as stereo, mono, left and right can be selected with the t u buttons.
8
buttons
Advertisement
Table of Contents
