Operation; Changing Channels - Strong SRT 7501 User Manual

6.0 OPERATION

In viewing mode, several features are available to make watching TV a true pleasure. This chapter
describes these features. Please also read chapter 7.0 to get familiar with the menu of your new receiver.

6.1 Changing channels

Your new receiver is equipped with three ways to change channels.
1. Via direct access
2. Via the channel list
3. Via the CH+/CH- or pq buttons
4. Via using the 9 button
6.1.1 Direct access
To gain direct access to a certain channel, simply input its number with the 0~9 buttons on the remote
control. Channel numbers can be up to four digits long. Entering a number with less than four digits is
possible. After entering the channel number just wait a few seconds or press OK and your receiver will
switch to the selected channel.
NOTE:
6.1.2 Channel list
Press OK in viewing mode to display the channel list. In the header section the corresponding name of
the selected channel list will be displayed, e.g. HD Austria Senderliste.Use pq inside the channel list to
highlight your channel of choice and press OK to switch to the highlighted channel.
The channel list is equipped with a filter function to make it easier to find your favourite channels. While
in the channel list, press RED. An alphabet banner will now be displayed. Use pq or P+/P- to select
the first letter or number of the channel you wish to filter for and press OK or t to change to the filtered
list. All channels beginning with the chosen letter will now be listed at the left side (ascending order by
channel number).
The following buttons are available in the channel list and in viewing mode:
TV/R:
Toggles between TV and radio channels, in channel list changes the list mode.
LIST:
Opens the satellite list selection in viewing and list mode in case there is more than 1
satellite installed.
FAV:
Displays the favourite list selection in both modes. Details about creating favourite lists
can be found in chapter 7.2.1 TV Channel Manager.
To return to the original respectively to the previous channel list /mode use TV/R or LIST.
6.1.3 Using the CH+/CH- buttons
CH+ or p will switch to a higher channel.
CH- or q will switch a lower channel.
10
Please note that when using the "HD Austria Senderliste" some channel
numbers may not be in the list or assigned. Personally stored or searched
channels will be stored from channel number 4000.