Table of Contents
Advertisement
5.0 QUICK GUIDE TO USING YOUR RECEIVER
We at STRONG understand that you eagerly anticipate enjoying your new HD receiver. We do, however,
recommend reading the full manual to get the best performance of your STRONG HD receiver.
To switch your receiver ON or to Standby, use the q button on the remote control. Choose a channel
with pq or the CH+/CH- buttons. Alternatively, you can choose the channel number with the 0~9
buttons on the remote control or press OK in viewing mode to display the channel list. The volume
can be adjusted with t u or the VOL+/VOL- buttons. The usage of VOL+/VOL- and ! is possible
in ALL menus which present a TV picture in the background and can be used in the videotext mode
additionally. P+/P- enables you to scroll page wise in all lists, which allows you to select channels or
other items as conveniently as possible.
To open the channel and programme* information, press the INFO button in viewing mode. In this state
it is possible to use t u to display channel and programme information about other channels without
switching channels, but however in this mode you can also switch to the selected channel by pressing
OK. Press INFO twice to display detailed programme information of the current or next programme.
For the current programme information use t u to change between the current and next event
information. In the respective programme information you can use P+/P- to scroll if applicable. If you
press the button a third time, technical details of this channel will be displayed. Press INFO or to close
the information.
* Programme information are displayed in case of availability. Availability depends on the broadcast.
NOTE:
6.0 OPERATION
In viewing mode, several features are available to make watching TV a true pleasure. This chapter
describes these features. Please also read chapter 7.0 to get familiar with the menu of your new receiver.
6.1 Changing channels
Your new receiver is equipped with three ways to change channels.
1. Via direct access
2. Via the channel list
3. Via the CH+/CH- or pq buttons
4. Via using the 9 button
6.1.1 Direct access
To gain direct access to a certain channel, simply input its number with the 0~9 buttons on the remote
control. Channel numbers can be up to four digits long. Entering a number with less than four digits is
possible. After entering the channel number just wait a few seconds or press OK and your receiver will
switch to the selected channel.
NOTE:
10
5 min after switching the receiver into Standby it will enter the deep sleep
mode. Within this time the receiver is able to start up quickly. Starting up
from deep sleep takes approx. 35 seconds.
When using the simpliTV List some channel numbers may not be assigned
or present in the list. Channels which have been searched manually or been
added personally (e.g. when you had installed another list before installing
the simpliTV List) will be assigned from channel number 400 onwards.
Advertisement
Table of Contents
