Quick Guide To Using Your Receiver; Operation; Changing Channels - Strong SRT 8221 User Manual

4.2.4 Scan
Your receiver will now perform an automatic channel search. When the process has been completed,
all found channels will be stored and the receiver will switch to the first found channel. You are now
ready to enjoy your new receiver.
NOTE:

5.0 QUICK GUIDE TO USING YOUR RECEIVER

We at STRONG understand that you can't wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We
do, however, advice you to read the full manual to get the best performance from your receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose the desired channel with the pq buttons. Alternatively, you can digit the channel number
with the 0~9 buttons on the remote control. Or press OK in viewing mode to display the channel list.
The volume can be adjusted with the t u buttons.

6.0 OPERATION

Your new receiver is equipped with several features to make watching TV a true pleasure. This
paragraph describes these features. Please also read chapter 7.0 to get familiar with the menu of your
receiver.

6.1 Changing channels

Your new receiver is equipped with four ways to change channels.
Via direct access using the 0~9 buttons.
„ „
Via the channel list trough OK button.
„ „
Via the PG+ and PG- keys.
„ „
Via the pq keys.
„ „
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the 0~9 keys on the remote
control. Channel numbers can be up to four digits long. Entering a number with less than four digits
is possible. Just wait a few seconds and your receiver will switch to the selected channel or press OK
immediately after selecting the channel number.
6.1.2 Channel list
Press OK in viewing mode to display the Channel List. Use pq in the Channel List to highlight your
channel of choice and press OK once to select the highlighted channel.
To search channels contained in the channel list press RED button and insert the channel name you
want to find, then select Ok or press EXIT to view the search results.
Use the BLUE button to select a different tuner (in the case both Satellite and Terrestrial) have been
scanned.
If no channels were found during the automatic channel scan, the receiver
will return to Installation guide menu. Please select your language again
and refer to chapter 7.3.1 for further instructions.
11