Installing The Superserver 6011H Into A Rack; Identifying The Sections Of The Rack Rails - Supermicro SUPERSERVER 6011H User Manual

2-4

Installing the SuperServer 6011H into a Rack

This section provides information on installing the SuperServer 6011H into
a rack unit. If the 6011H has already been mounted into a rack, you can
skip ahead to Sections 2-5 and 2-6. There are a variety of rack units on
the market, which may mean the assembly procedure will differ slightly.
The following is a general guideline for installing the 6011H into a rack with
the rack rails provided. You should also refer to the installation instructions
that came with the rack unit you are using.

Identifying the Sections of the Rack Rails

You should have received two rack rail assemblies with the SuperServer
6011H. Each of these assemblies consist of two sections: an inner fixed
chassis rail that secures to the 6011H (A) and an outer fixed rack rail that
secures directly to the rack itself (B). A sliding rail guide sandwiched
between the two should remain attached to the fixed rack rail. (See Figure
2-1.) The A and B rails must be detached from each other to install.
To remove the fixed chassis rail (A), pull it out as far as possible - you
should hear a "click" sound as a locking tab emerges from inside the rail
assembly and locks the inner rail. Then depress the locking tab to pull the
inner rail completely out. Do this for both the left and right side rack rail
assemblies.
Mounting Holes
Figure 2-1.
A
Identifying the Sections of the Rack Rails
2-3
Chapter 2: Server Installation
B
Locking Tab