Speaker Enable/Disable; Onboard Lan1 (Nic) Enable/Disable; Onboard Lan2 (Nic) Enable/Disable; Spread Spectrum Enable/Disable - Supermicro SUPERSERVER 6011H User Manual

Speaker Enable/Disable

You may want to disable the
onboard speaker.
gives you this option.
table on the right for jumper set-
tings.
Onboard LAN1 (NIC)
Enable/Disable
Change the setting of jumper JP58
to enable or disable the onboard
LAN1 (or Network Interface Card)
on your motherboard.
table on the right for jumper set-
tings.
Onboard LAN2 (NIC)
Enable/Disable
Change the setting of jumper JP62
to enable or disable the onboard
LAN1 (or Network Interface Card)
on your motherboard.
table on the right for jumper set-
tings.
Spread Spectrum Enable/
Disable
Jumper JP3 is used to enable or dis-
able the Spread Spectrum feature.
Spread Spectrum is a technique
used to stabilize operation when a
system is being affected by electro-
magnetic interference.
(default) position is open to disable
Spread Spectrum. See the table on
the right for jumper settings.
Jumper JP56
See the
See the
See the
The normal
5-21
Chapter 5: Installation
Speaker Enable/Disable
Jumper Settings (JP56)
Jumper
Position Definition
Open Disabled
Closed Enabled
Onboard LAN1 (NIC)
Enable/Disable
Jumper Settings (JP58)
Jumper
Position Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
Onboard LAN2 (NIC)
Enable/Disable
Jumper Settings (JP62)
Jumper
Position Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
Spread Spectrum
Jumper Settings (JP3)
Jumper
Position Definition
Open Disabled
Closed Enabled