Installing The Superserver 6013P-8 Into A Rack; Identifying The Sections Of The Rack Rails - Supermicro SUPERSERVER 6013P-8 User Manual

S S
UPER ERVER 6013P-8 Manual
2-4

Installing the SuperServer 6013P-8 into a Rack

This section provides information on installing the SuperServer 6013P-8 into
a rack unit. If the 6013P-8 has already been mounted into a rack, you can
skip ahead to Sections 2-5 and 2-6. There are a variety of rack units on
the market, which may mean the assembly procedure will differ slightly.
The following is a guideline for installing the 6013P-8 into a rack with the
rack rails provided.
that came with the rack unit you are using.

Identifying the Sections of the Rack Rails:

You should have received two rack rail assemblies with the SuperServer
6013P-8. Each of these assemblies consist of three sections: an inner
fixed chassis rail that secures to the 6013P-8 (A) and an outer fixed rack
rail that secures directly to the rack itself (B). A sliding rail guide sand-
wiched between the two should remain attached to the fixed rack rail.
(See Figure 2-1.) The A and B rails must be detached from each other to
install.
To remove the fixed chassis rail (A), pull it out as far as possible - you
should hear a "click" sound as a locking tab emerges from inside the rail
assembly and locks the inner rail. Then depress the locking tab to pull
the inner rail completely out. Do this for both the left and right side rack
rail assemblies.
Mounting Holes
Figure 2-1.
You should also refer to the installation instructions
A
Identifying the Sections of the Rack Rails
2-4
B
Locking Tab