Table of Contents
Advertisement
Checkpoint
88h
89h
8Bh
8Ch
8Dh
8Fh
91h
95h
96h
97h
98h
99h
9Ah
9Bh
9Ch
9Dh
9Eh
Appendix B: AMIBIOS POST Diagnostic Error Codes
Code Description
executing the AMIBIOS Setup or WINBIOS Setup utility
next.
Returned from WINBIOS Setup and cleared the screen.
Performing any necessary programming after WINBIOS
Setup next.
The programming after WINBIOS Setup has completed.
Displaying the power on screen message next.
The first screen message has been displayed. The
<WAIT...> message is displayed. Performing the PS/2
mouse check and extended BIOS data area allocation
check next.
Programming the WINBIOS Setup options next.
The WINBIOS Setup options are programmed. Resetting
the hard disk controller next.
The hard disk controller has been reset. Configuring the
floppy drive controller next.
The floppy drive controller has been configured.
Configuring the hard disk drive controller next.
Initializing the bus option ROMs from C800 next. See the
last page of this chapter for additional information.
Initializing before passing control to the adaptor ROM at
C800.
Initialization before the C800 adaptor ROM gains control
has completed. The adaptor ROM check is next.
The adaptor ROM had control and has now returned
control to BIOS POST. Performing any required
processing after the option ROM returned control.
Any initialization required after the option ROM test has
completed. Configuring the timer data area and printer
base address next.
Set the timer and printer base addresses. Setting the
RS-232 base address next.
Returned after setting the RS-232 base address.
Performing any required initialization before the
coprocessor test next.
Required initialization before the Coprocessor test is
over. Initializing the coprocessor next.
Coprocessor initialized. Performing any required
initialization after the Coprocessor test next.
Initialization after the Coprocessor test is complete.
Checking the extended keyboard, keyboard ID, and
B-7
Advertisement
Table of Contents
