Table of Contents
Advertisement
SUPERSERVER 6011H User's Manual
Checkpoint
54h
57h
58h
59h
60h
62h
65h
66h
67h
7Fh
80h
81h
82h
83h
84h
85h
86h
87h
Code Description
Shutdown was successful. The CPU is in real mode.
Disabling the Gate A20 line, parity, and the NMI next.
The A20 address line, parity, and the NMI are disabled.
Adjusting the memory size depending on relocation and
shadowing next.
The memory size was adjusted for relocation and
shadowing. Clearing the Hit <DEL> message next.
The Hit <DEL> message is cleared. The <WAIT...>
message is displayed. Starting the DMA and interrupt
controller test next.
The DMA page register test passed. Performing the
DMA Controller 1 base register test next.
The DMA controller 1 base register test passed.
Performing the DMA controller 2 base register test next.
The DMA controller 2 base register test passed.
Programming DMA controllers 1 and 2 next.
Completed programming DMA controllers 1 and 2.
Initializing the 8259 interrupt controller next.
Completed 8259 interrupt controller initialization.
Extended NMI source enabling is in progress.
The keyboard test has started. Clearing the output
buffer and checking for stuck keys. Issuing the
keyboard reset command next.
A keyboard reset error or stuck key was found.
Issuing the keyboard controller interface test command
next.
The keyboard controller interface test completed.
Writing the command byte and initializing the circular
buffer next.
The command byte was written and global data
initialization has completed. Checking for a locked key
next.
Locked key checking is over. Checking for a memory
size mismatch with CMOS RAM data next.
The memory size check is done. Displaying a soft error
and checking for a password or bypassing WINBIOS
Setup next.
The password was checked. Performing any required
programming before WINBIOS Setup next.
The programming before WINBIOS Setup has com-
pleted. Uncompressing the WINBIOS Setup code and
B-6
Advertisement
Table of Contents
