Table of Contents
Advertisement
About This Manual
This manual is written for professional system integrators and PC techni-
cians.
It provides information for the installation and use of the Super-
Server 6011H. Installation and maintainance should be performed by expe-
rienced technicians only.
The SuperServer 6011H is a high-end dual processor 1U rackmount server
based on the SC810 1U rackmount server chassis and the P3TDER+, a dual
processor motherboard that supports single or dual Intel Pentium
500 MHz-1.40 GHz processors at front bus speeds of 133 and 100 MHz
and up to 4 GB SDRAM main memory.
Manual Organization
Chapter 1: Introduction
The first chapter provides a checklist of the main components included with
the server system and describes the main features of the SUPER P3TDER+
mainboard and the SC810 chassis, which make up the SuperServer 6011H.
Chapter 2: Server Installation
This chapter describes the steps necessary to install the SuperServer
6011H into a rack and check out the server configuration prior to powering
up the system. If your server was ordered without processor and memory
components, this chapter will refer you to the appropriate sections of the
manual for their installation.
Chapter 3: System Interface
Refer here for details on the system interface, which includes the functions
and information provided by the control panel on the chassis as well as
other LEDs located throughout the system.
Preface
iii
Preface
®
III FCPGA
Advertisement
Table of Contents
