Table of Contents
Advertisement
5-4
I/O Ports
The I/O ports are color coded in conformance with the PC 99 specification.
See Figure 5-2 below for the colors and locations of the various I/O ports.
Mouse
(Green)
Keyboard
USB Ports
(Purple)
Figure 5-2. P3TDER+ Rear Panel I/O Ports
5-5
Installing Processors
!
1.
Installing the FCPGA processors:
The P3TDER+ has two 370-pin sockets to support single or dual Intel
®
Pentium
III FCPGA 500 MHz-1.40 GHz processors with a 512K L2 cache
at front bus speeds of 100 and 133 MHz. (You must use the server
version of these processors.) Lift the lever on the FCPGA socket and
insert the processor keeping the notched corner oriented toward pin one
on the socket. Make sure the processor is fully seated in the socket and
then close the lever. You can also install a single processor on the
motherboard without changing any jumper settings. (Install a single
processor into the socket marked "CPU1".) See Figure 5-3 for views of a
370-pin FCPGA socket before and after processor installation.
COM1 Port
(Turquoise)
Avoid placing direct pressure to the top of the pro-
cessor package.
and always remove it before adding, removing or
changing any hardware components.
VGA (Monitor)
Port (Blue)
Always connect the power cord last
5-5
Chapter 5: Installation
LAN1
LAN2
Advertisement
Table of Contents
