Table of Contents
Advertisement
Chapter 2: Server Installation
2-4
Installing the SuperServer 6021i into a Rack
This section provides information on installing the SuperServer 6021i into
a rack unit.
If the 6021i has already been mounted into a rack, you can
skip ahead to Sections 2-5 and 2-6. There are a variety of rack units on
the market, which may mean the assembly procedure will differ slightly.
The following is a guideline for installing the 6021i into a rack with the
rack rails provided.
You should also refer to the installation instructions
that came with the rack unit you are using.
Identifying the Sections of the Rack Rails:
You should have received two rack rail assemblies with the SuperServer
6021i. Each of these assemblies consist of three sections: an inner fixed
chassis rail that secures to the 6021i (A) and an outer fixed rack rail that
secures directly to the rack itself (B). A sliding rail guide sandwiched
between the two should remain attached to the fixed rack rail. (See Figure
2-1.) The A and B rails must be detached from each other to install.
To remove the fixed chassis rail (A), pull it out as far as possible - you
should hear a "click" sound as a locking tab emerges from inside the rail
assembly and locks the inner rail. Then depress the locking tab to pull the
inner rail completely out. Do this for both the left and right side rack rail
assemblies.
A
B
Figure 2-1.
Identifying the Sections of the Rack Rails
2-3
Advertisement
Table of Contents
