Appendix C System Specifications - Supermicro SUPERSERVER 6011H User Manual

Appendix C: System Specifications
Appendix C
System Specifications
Processors
®
Single or dual Pentium III FCPGA 500 MHz-1.40 GHz processors
(server version) with a 512K L2 cache at front bus speeds of 133
and 100 MHz.
Note: Please refer to the support section of our web site for a complete listing of supported
processors. (http://www.supermicro.com/TechSupport.htm)
Chipset
ServerWorks ServerSet III HE Super Light
BIOS
®
4 Mb AMI Flash ROM
APM 1.2, DMI 2.1, PCI 2.2, ACPI 1.0, Plug and Play (PnP)
Memory Capacity
Four 168-pin DIMM sockets supporting up to 4 GB registered ECC
SDRAM
Notes: The memory speed must match the front side bus speed being used (both 133 or 100
MHz).
The DIMM slots on the P3TDER+ are set at a 25° angle to provide a low vertical profile.
Memory modules should be installed in pairs (first in the two slots of Bank0, then in both slots
of Bank 1, if needed).
DIMM Sizes
128 MB / 256 MB / 512 MB / 1 GB PC100/133 SDRAM modules supported
SCSI Controller
Adaptec AIC-7899 for dual channel Ultra160 SCSI
SCSI SCA Backplane Controller
QLogic GEM318 controller for SAF-TE compliance (optional)
SCSI Drive Bays
Two (2) drive bays to house two (2) standard 1" 80-pin SCA SCSI
drives
C-1