Table of Contents
Advertisement
SUPERSERVER 6011H User's Manual
Checkpoint
24h
25h
27h
28h
2Ah
2Eh
2Fh
30h
31h
32h
34h
37h
38h
39h
3Ah
3Bh
40h
42h
Code Description
The configuration required before interrupt vector
initialization has completed. Interrupt vector initialization
is about to begin.
Interrupt vector initialization is done. Clearing the
password if the POST DIAG switch is on.
Any initialization before setting video mode will be done
next.
Initialization before setting the video mode is complete.
Configuring the monochrome mode and color mode
settings next.
Bus initialization system, static, output devices will be
done next, if present. See the last page for additional
information.
Completed post-video ROM test processing. If the EGA/
VGA controller is not found, performing the display
memory read/write test next.
The EGA/VGA controller was not found. The display
memory read/write test is about to begin.
The display memory read/write test passed. Look for
retrace checking next.
The display memory read/write test or retrace checking
failed. Performing the alternate display memory read/
write test next.
The alternate display memory read/write test passed.
Looking for alternate display retrace checking next.
Video display checking is over. Setting the display
mode next.
The display mode is set. Displaying the power on
message next.
Initializing the bus input, IPL, general devices next, if
present. See the last page of this chapter for additional
information.
Displaying bus initialization error messages. See the
last page of this chapter for additional information.
The new cursor position has been read and saved.
Displaying the Hit <DEL> message next.
The Hit <DEL> message is displayed. The protected
mode memory test is about to start.
Preparing the descriptor tables next.
The descriptor tables are prepared. Entering protected
mode for the memory test next.
B-4
Advertisement
Table of Contents
