Appendix B System Specifications - Supermicro FatTwin F618R3-FT User Manual

Appendix B: System Specifications
Appendix B
System Specifications
Note: Unless noted specifications apply to a complete system (all serverboards).
There are eight serverboard drawer nodes per system.
Processors
Two E5-2600 v3/v4 series processors per node in Socket R3 LGA 2011 type
sockets
Note: please refer to our website for details on supported processors.
Chipset
One PCH C612 chipset per node
BIOS
16 MB AMI SPI BIOS® Flash ROM Flash EEPROM per node
Memory Capacity
The X10DRFF's integrated memory controller supports up to eight (8) DIMM slots
supporting up to 1 TB of DDR4-2400/2133/1866/1600 MHz speed 3DS LRDIMM
registered ECC or 512 GB of DDR4-2400/2133/1866/1600 MHz speed RDIMM
SDRAM in up to 1 GB, 2 GB, 4 GB, 8 GB, 16 GB, 32 GB, 64 GB or 128 GB (3DS
LRDIMM only) size at 1.20Vs voltages per node.
Note: refer to Section 5-5 for details on installation.
Note: Check the Supermicro website (www.supermicro.com) for the latest memory support
information.
SATA Drive Bays
Each node of the FatTwin F618R3-FT contains two (2) fixed 3.5" SATA drives.
PCI Expansion
The FatTwin F618R3-FT has one (1) PCI-Exp 3.0 x16 slots available per node.
Serverboard
X10DRFF serverboard (proprietary form factor)
Dimensions: (LxW) 18.724" x 8.539" x (475.59 mm x 216.87 mm)
B-1