Set Time (Command-Menu) - Mircom FR-320 Series Installation And Operation Manual

Command Menu-->Panel Config-->Features
17. Active EOL
Ac ti ve EOL
[X ] D I S AB LE
9.5.3 Command Menu-->Panel Config-->Default Config
Command Menu-->Panel Config-->
Default Config
4. Default Config
Lo ad the defau l t
S etti ngs? Y
9.6

2. Set Time (Command-Menu)

!
Attention: In order for the panel to keep accurate logs, it must have the correct
i
Note:
1. Daylight Save
2. Time Clock
3. Compensation
Command Menu/Set time Date
1. Daylight saving time
Daylight Saving
[X] Disable
52
[X] DISABLE->Default
[ ] ENABLE
Y-->Default
time, date, daylight saving time, and time compensation.
It is critical to configure these settings on the panel before operation.
Annual Maintenance Requirement:
Verify annually that the time, date, daylight saving time, and time
compensation are correct. In addition, Mircom recommends keeping a
log of when these settings were checked.
See section 2. Set Time (Command-Menu) on page 52.
Refer to How to Use the Keypad to Program the FR-320 on page 45 for detailed
instructions on making menu selections.
[X] DISABLE ->Default
[ ] ENABLE
Enable this function if you are using
an active EOL resistor or ICAC-306
(ICAC-306 has built in Active EOL
resistors).
Use this function to reset the panel to
the default configuration of the chosen
programming mode.
Use this function to enable daylight savings
time.