Set Time (Command-Menu); Command Menu-->Panel Config-->Default Config - Mircom FR-320 Series Installation And Operation Manual

Command Menu-->Panel Config-->Features
16. Sig-Sil NAC
S i l enc eabl e N AC
[X ] N AC-1
Command Menu/FR-320 Config/Features/
17. Active EOL
Ac ti ve EOL
[X ] D I S AB LE
10.5.3 Command Menu-->Panel Config-->Default Config
Command Menu-->Panel Config-->
Default Config
4. Default Config
Lo ad the defau l t
S etti ngs? Y
10.6

2. Set Time (Command-Menu)

i
Note:
1. Daylight Save
2. Time Clock
3. Compensation
Command Menu/Set time Date
1. Daylight saving time
Daylight Saving
[X] DISABLE
Command Menu/Time Clock
2. Set time and date
HH:MM WKD YYYY-MM-DD
00:00 MON 2000-01-01
56
[X] NAC-1->Default
[X] NAC-2->Default
[X] DISABLE->Default
[ ] ENABLE
Y-->Default
Refer to 10.3 How to Use the Keypad to Program the FR-320 on page 49 for
detailed instructions on making menu selections.
[X] DISABLE ->Default
[ ] ENABLE
Default
00:00 MON 2000-01-01
Use this function to set which NAC
circuits are silenceable or non-
silenceable.
Enable this function if using an
Active EOL. If ICAC-306 is used,
this function should be enabled
since the Class A Converter has
built in Active EOL resistors.
Use this function to reset the panel
to the default configuration of the
chosen programming mode.
Use this function to enable daylight savings
time.
Use this function to set the time and date.
Use the "LEFT" and "RIGHT" keys to move
the cursor to the desired location in the
display and use the "UP" and "DOWN" keys
to increase or decrease the values. Press
the "ENTER" key to accept the changes and
the "CANCEL" key to ignore the changes.
Note: time is in 24hr format
Configuration