Output - Sharp MX-2300N User Manual

OUTPUT

To select output functions and the output tray, touch the [Output] key in the base screen of copy mode. Output functions
that can be selected are sort, group, offset, staple sort, saddle stitch, and punch. All settings are explained in this section
based on the assumption that a saddle stitch finisher, punch module and right tray are installed.
(1) (2)
(1) [Group] key
This is used to group copies by page.
☞
Group mode (page 43)
(2) [Staple Sort] key
This is used to sort the output into sets, staple each set,
and deliver the sets to the tray. (Note that the sets will not
be offset in the output tray.) When this function is
selected, three keys will appear for selecting the staple
position.
☞
Staple sort function / Saddle stitch function
(3) [Sort] key
This is used to sort (collate) output into sets.
☞
Sort mode (page 43)
(4) Output display
An icon will appear to indicate the output mode.
(5) [Offset Tray] key ([Center Tray] key*)
This is used to offset each set of output from the previous
set in the offset tray (center tray). The [Offset Tray] key is
automatically selected when the [Staple Sort] key is
selected.
* When only a right tray is installed, this appears as the
"Center tray".
The keys that appear and that can be selected will vary depending on what peripheral devices are installed.
Depending on what peripheral devices are installed, it may not be possible to select certain keys. If your screen is different
from the above screen, see the screens below.
Display example 1
The screen when a right tray, finisher,
and saddle finisher are not installed.
Output
Sort
Group
Offset
(3)
Output
Sort
Staple
Sort
Group
(page 44)
Display example 2
The screen when a right tray is installed.
Output
OK
Sort
Group
(4) (5) (6)
Offset
Right Tray
Tray
Offset
(8)
(6) [Right Tray] key
Select this key to have output delivered to the right tray.
When the right tray is selected, offset, staple sort, saddle
stitch, and punch cannot be selected.
(7) [OK] key
Touch this key to close the output screen and return to
the base screen.
(8) [Offset] key
This is used to offset each set of output from the previous set.
The offset function operates when the checkbox is
selected
not selected
cleared when the staple sort function is selected.)
☞
Offset function
(9) [Saddle Stitch] key
This is used to staple and fold each set of copies at the centerline.
☞
Staple sort function / Saddle stitch function
When this key is touched, the saddle stitch setting screen
appears. (Only when "Automatic Saddle Stitch" is
enabled in the system settings (administrator).)
(10) [Punch] key
This is used to punch holes in the output.
☞
Punch function
Center
Right Tray
Tray
Offset
42
(7)
OK
Saddle
Stitch Punch
(9) (10)
and does not operate when the checkbox is
. (The offset checkmark is automatically
(page 43)
(page 45)
Display example 3
The screen when a right tray, finisher
and punch module are installed.
Output
OK
Offset
Tray
Sort
Staple
Sort
Group
Offset
(page 44)
OK
Right Tray
Punch