Interface Settings - Sharp MX-2300N User Manual

Interface Settings

These settings are used to control and monitor data transmitted to the USB port or network port of the machine.
Touch the [Printer Settings] key, touch the [Interface Settings] key, and configure the settings.
Hexadecimal Dump Mode
This function is used to print the print data from a
computer in hexadecimal format together with the
corresponding ASCII text. This allows you to check
whether or not print data from the computer is being
transmitted to the machine correctly.
Example of a hexadecimal dump
To enable this setting, select the checkbox
touch the [OK] key.
I/O Timeout
The I/O timeout can be set to any number of seconds
from 1 to 999.
The I/O timeout function temporarily breaks the
connection if the set duration of time elapses without any
data being received by the port. After the connection is
broken, the port is set to auto selection or the next print
job is begun.
Specify the time with the
[OK] key. (To make the number change quickly, keep
your finger on the or
Enable USB Port
This is used to enable printing from the USB port.
To enable this setting, select the checkbox
touch the [OK] key.
and
keys and touch the
key.)
and
USB Port Emulation Switching
If the machine is connected using the USB port, select
the emulated printer language. The settings are the
same as those of
• Auto*
• PostScript*
• PCL
Select one of the keys and touch the [OK] key.
* When the PS3 expansion kit is installed.
Unless printer errors occur frequently, it is
recommended that you use the factory default setting
"Auto".
Enable Network Port
This is used to enable printing from the network port.
To enable this setting, select the checkbox
touch the [OK] key.
Network Port Emulation Switching
This setting is used to select the emulated printer
language when the machine is connected by a network
port. The settings are the same as those of
Emulation Switching".
• Auto*
• PostScript*
• PCL
Select one of the keys and touch the [OK] key.
* When the PS3 expansion kit is installed.
Unless printer errors occur frequently, it is
recommended that you use the factory default setting
"Auto".
102
"Network Port Emulation Switching".
and
"USB Port