Fax Reception; Receiving Faxes - Sharp MX-2300N User Manual

4

FAX RECEPTION

This chapter explains the basic procedures for receiving a fax.

RECEIVING FAXES

When "Auto Reception" is enabled, the machine will receive faxes automatically.
The fax reception mode is displayed in the base screen.
This shows the current fax
reception mode and the amount
of free memory remaining.
• When fax reception is in progress, it is possible to reserve a transmission by performing the transmission in memory
transmission mode.
☞
TRANSMISSION METHODS
• To print received faxes, make sure that the required paper is loaded in the machine's paper trays. It is not necessary to
load 8-1/2" x 11" (A4) paper and 5-1/2" x 8-1/2" (B5) paper in both the vertical (
Differences in orientation are automatically adjusted when faxes are received.
When a fax smaller than 8-1/2" x 11" (A4) size is received, the size of the paper used for printing will vary depending on the
orientation (vertical or horizontal) in which the sender placed the original.
• System Settings for Fax: Fax Receive Settings
This is used to change the fax reception mode. "Auto Reception" should normally be used.
Select "Manual Reception" when an extension phone is connected to the machine.
☞
Fax Receive Settings
• System Settings for Fax (Administrator):
This setting is used to enter fax numbers from which you wish to block reception.
Ready to send.
Fax
Mode Switch
Image
Settings
Memory TX
Direct TX
Auto Reception
Fax Memory:100%
(page 13)
(page 160)
Anti Junk Fax Setting
Speaker Resend
Address Book
Sub Address
Special Modes
File
Quick File
(page 183)
45
) and horizontal ( ) orientations.