Specifying The Send Size - Sharp MX-2300N User Manual

SPECIFYING THE SEND SIZE

Specify the send size as a paper size. If a send size bigger than the scan size is selected, the image will be enlarged. If
a send size smaller than the scan size is selected, the image will be reduced. The enlargement/reduction ratio that is set
using this procedure will be automatically cleared after the transmission is completed.
The send size cannot be specified when the scan size is [Long Size] or is specified by numbers.
Fax
Mode Switch
Exposure
Image
Settings
Standard
Resolution
Memory TX
1
Direct TX
Auto 8 x11
Original
Auto Reception
Fax Memory:100%
(1)
Fax
Scan Size
Original
Auto 8 x11
2
2-Sided
Booklet
2-Sided
Tablet
Fax
Original
5 x8
Auto
Manual 5 x8 R 1 / 2
8 x11
8 x11 1 / 2
3
• Depending on the paper size specified for the "Scan Size", it may not be possible to select some sizes for the "Send
Size". Size keys that cannot be specified for the "Send Size" are grayed out to prevent selection.
• To specify an AB size for the send size, touch the [AB
send size.
Fax
Scan Size
Original
Auto
2-Sided
Booklet
2-Sided
Tablet
4
The enlargement/reduction ratio appears between the "Scan Size" key and the "Send Size" key.
Auto
1 / 2
Special Modes
(2)
100%
Send Size
1 / 2 Auto
Image Orientation
Inch
AB
1 / 2 1 / 2 11x17
8 x11R 1 / 2
1 / 2 8 x13(216x330) 1 / 2
1 / 2
1 / 2 8 x14
(1)
129%
Send Size
1 / 2
8 x11 11x17
Image Orientation
(1)
Display the original settings screen.
Address Book
(1) Touch the [Image Settings] key.
Sub Address
Special Modes
(2) Touch the [Original] key.
File
Quick File
Touch the [Send Size] key.
OK
Specify the send size.
OK
(1) Touch the desired send size key.
(2) Touch the [OK] key.
(2)
Inch] key to highlight the [AB] side and then specify the
Specify the Image orientation of the
OK
original.
(1) Touch the appropriate [Image Orientation]
key.
If the wrong orientation is selected here, the image may
(2)
not be sent properly when using enlargement/reduction.
(2) Touch the [OK] key.
33