Water Pump And Oil Cooler; Front Cover - Kubota WSM 07-E3B Series Workshop Manual

07-E3B SERIES, WSM

(7) Water Pump and Oil Cooler

(8) Front Cover

Water Pump (If necessary)
1. Remove the water pump (1).
(When reassembling)
• When mounting the water pump (1), use the new water pump
gasket.
(1) Water Pump
Oil Cooler
1. Remove the water pipe (2).
2. Remove the oil filter cartridge (1) and the oil cooler joint screw
(3).
3. Remove the oil cooler (4).
Tightening Oil cooler
torque joint screw
(1) Oil Filter Cartridge
(2) Water Pipe
Front Cover
1. Remove the front cover (1).
(When reassembling)
• Confirm that the front cover gasket (4) set in position.
• Confirm that the liquid gasket coating surface is free of water,
dust and oil in order to maintain sealing effect.
NOTE

• Assemble the adhesive-applied parts within ten minutes.
• Apply a liquid gasket (Three Bond 1217H or equivalent) (5)
to the seam between crankcase 1 (3) and crankcase 2 (2).
[7T screw]
V2607-DI-E3B
V2607-DI-T-E3B
Front
V3007-DI-T-E3B
Tightening cover
V3307-DI-T-E3B
torque mounting
screw
[10T screw]
V3007-DI-T-E3B
V3307-DI-T-E3B
(1) Front Cover
(2) Crankcase 2
(3) Crankcase 1
S-65
64 to 73 N·m
V2607-DI-E3B
6.5 to 7.5 kgf·m
V2607-DI-T-E3B
47 to 54 lbf·ft
40 to 44 N·m
V3007-DI-T-E3B
4.0 to 4.5 kgf·m
V3307-DI-T-E3B
29 to 32 lbf·ft
(3) Oil Cooler Joint Screw
(4) Oil Cooler
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
30 to 34 N·m
3.0 to 3.5 kgf·m
22 to 25 lbf·ft
(4) Front Cover Gasket
(5) Liquid Gasket
KiSC issued 06, 2020 A
ENGINE
W1187742
W1032266
W1189218