Kubota WSM 07-E3B Series Workshop Manual page 203

07-E3B SERIES, WSM
Replacing Small End Bushing (for V3007-DI-T-E3B / V3307-DI-T-
E3B)
[Serial No. : to 9DZ999]
(When removing)
1. Install the guide 3 onto the replacing tool shaft.
2. Press out the used bushing using replacing tool.
(When installing)
1. Clean a new small end bushing and apply engine oil to it.
2. Install the guide 4, new bushing, the guide 5 and bolt onto the
replacing tool shaft.
3. Press-fit the new bushing with a press.
4. Turn the connecting rod inside out.
5. Press-fit another new bushing similarly.
[Serial No. : 9E0001 and above]
(When removing)
1. Press out the used bushing using a small end bushing replacing
tool. (Refer to "5. SPECIAL TOOLS" at "GENERAL" section.)
(When installing)
1. Clean a new small end bushing and bore, and apply engine oil to
them.
2. Insert a new bushing onto the tool and press-fit it with a press so
that the seam (11) of bushing position as shown in the figure, until
it is flash with the connecting rod.
(1) Guide 1
(2) Connecting Rod
(3) Guide 2
(4) Base
(5) Shaft
(6) Guide 3
(7) Bushing
(8) Guide 4
(9) Guide 5
(10)Bolt
(11)Seam
S-100
ENGINE
(A) When Removing
(B) When Installing
(C) 0.26 rad (15 °)
W1415434
KiSC issued 06, 2020 A