Kubota WSM 07-E3B Series Workshop Manual page 75

07-E3B SERIES, WSM
Balancer Shaft 1 Bearing A Replacing Tool (for V3007 / V3307 Balancer Model)
Application: Use to press fit the bearing.
A 18.0 mm (0.709 in.)
B 130 mm (5.12 in.)
C 1.2 mm (0.047 in.)
D 34.0 mm (1.34 in.)
E 99.0 mm (3.90 in.)
4.000 to 4.018 mm dia., 7.0 mm depth
F
(0.1575 to 0.1581 in. dia., 0.28 in. depth)
G 53.0 mm dia. (2.09 in. dia.)
H 48.80 to 48.90 mm dia. (1.922 to 1.925 in. dia.)
I 0.52 rad (30 °)
J 40.0 mm dia. (1.57 in. dia.)
K 20.0 mm dia. (0.787 in. dia.)
L 34.90 to 35.00 mm dia. (1.374 to 1.377 in. dia.)
M 1.5 mm (0.059 in.)
N 5.5 to 6.5 mm (0.22 to 0.25 in.)
O 33.0 mm (1.30 in.)
P 134 mm (5.28 in.)
Q 167 mm (6.57 in.)
R 1.53 rad (87.5 °)
S 35.0 mm dia. (1.38 in. dia.)
(1) Shaft Material : S43C-D (2) Stopper Material : SS400
T 23.0 mm (0.906 in.)
U 0.35 rad (20 °)
V 24.0 mm (0.945 in.)
W 12.0 mm (0.472 in.)
X 12.0 mm (0.472 in.)
Y 12.0 mm (0.472 in.)
Z 4.0 mm (0.16 in.)
a 3.0 mm (0.12 in.)
b 35.0 mm (1.38 in.)
c 53.0 mm (2.09 in.)
d 3.0 mm (0.12 in.)
e 2.0 mm (0.079 in.)
f Ra = 3.2 a
g 0.80 mm radius (0.031 in. radius)
h 0.30 mm radius (0.012 in. radius)
i 7.0 mm radius (0.28 in. radius)
j 0.40 mm radius (0.016 in. radius)
C0.5 Chamfer 0.50 mm (0.020 in.)
C1 Chamfer 1.0 mm (0.039 in.)
G-57
G GENERAL
KiSC issued 06, 2020 A