Kubota WSM 07-E3B Series Workshop Manual page 184

07-E3B SERIES, WSM
Reassembling the Brush
1. Fit the brush with its sliding face in the clockwise direction when
viewed from front.
IMPORTANT

• Be sure to keep the 2 brushes deep in the brush holder.
Otherwise the rotor and the rear section can not be fitted
into the position.
• Use a 4.0 mm (0.16 in.) hex. wrench to push the brushes into
place.
• Using a pin-pointed (2.0 mm (0.079 in.)) punch, keep the
brushes from popping out.
2. Match the tally line of the front section with that of the rear
section.
3. Tighten the 4 screws, and draw out the pin-pointed punch out of
the brush holder.
(1) Marking
Bearing at Slip Ring Side
1. Lightly secure the rotor (1) with a vise to prevent damage, and
remove the bearing (2) with a puller (3).
(1) Rotor
(2) Bearing
S-81
ENGINE
W1075117
(3) Puller
W1019701
KiSC issued 06, 2020 A