Kubota WSM 07-E3B Series Workshop Manual page 202

07-E3B SERIES, WSM
Replacing Small End Bushing (for V2607-DI-E3B / V2607-DI-T-
E3B)
(When removing)
1. Press out the used bushing.
(When installing)
1. Clean a new small end bushing and bore, and apply engine oil to
them.
2. Set the guide (4) to the bore of the connecting rod (2).
3. Insert a new first bushing (3) onto the small end bushing
replacing tool. (Refer to "5. SPECIAL TOOLS" at "GENERAL"
section.)
4. Press-fit it with a press so that the seam (6) of bushing position
as shown in the figure.
5. Turn the connecting rod inside out, and press-fit the second
bushing similarly.
(1) Small End Bushing Replacing Tool
(2) Connecting Rod
(3) First Bushing
(4) Guide
(5) Second Bushing
(6) Seam
(7) Oil Hole
(8) Mark
S-99
ENGINE
(A) When Installing First Bushing
(B) When Installing Second Bushing
(C) 0.26 rad (15 °)
W1066057
KiSC issued 06, 2020 A