Kubota WSM 07-E3B Series Workshop Manual page 210

07-E3B SERIES, WSM
Replacing Crankshaft Sleeve
1. Remove the used crankshaft sleeve (2).
2. Set the sleeve guide (3) to the crankshaft gear (1).
3. Heat a new crankshaft sleeve (2) to a temperature between 150
and 200 °C (302 and 392 °F), and fix the sleeve to the crankshaft
as shown in figure.
4. Press fit the sleeve using the crankshaft sleeve replacing tool (4).
(Refer to "5. SPECIAL TOOLS" at "GENERAL" section.)
NOTE

• Mount the sleeve with its largely chamfered surface facing
outward.
• Keep the space ((a) or (c)) between the edge of the
crankshaft gear (1) and the crankshaft sleeve (2).
• Be sure to place the seal (5) when reassembling.
(1) Crankshaft Gear
(2) Crankshaft Sleeve
(3) Sleeve Guide
(4) Crankshaft Sleeve Replacing Tool
(5) Seal
S-107
ENGINE
(a) 0.850 to 1.15 mm
(0.0335 to 0.0452 in.)
(b) 5.5 mm (0.22 in.)
(c) More than 6.5 mm (0.26 in.)
A : V2607-DI-E3B / V2607-DI-T-E3B
B : V3007-DI-T-E3B / V3307-DI-T-E3B
W1262151
KiSC issued 06, 2020 A