Kubota WSM 07-E3B Series Workshop Manual page 166

07-E3B SERIES, WSM
Installing Procedure of Injection Pump Assembly
1. Install the fuel injection pump assembly (2) in its unit (1), and
tighten the mounting screws and nuts.
2. Hook the governor connecting rod (4) to the rack pin (5) of the
fuel injection pump assembly (2).
3. Tighten the mounting screws and nuts with the specified torque,
not to slide off the governor connecting rod (4) from the rack pin
(5).
4. Remove the top cover (3) and place the service jig (6) to the hole
of the fuel injection pump unit (1).
TOOLS" at "GENERAL" section.)
5. Make sure the permanent magnet at the tip of the service jig (6)
is attracted to the governor connecting rod (4).
6. Slightly tighten the lock nut (7) of the governor connecting rod (4).
7. Holding down the service jig (6) by hand, tighten up the lock nut
(7) to the specified torque.
8. Hook the start spring (8) to the rack pin (5).
(1) Fuel Injection Pump Unit
(2) Fuel Injection Pump Assembly
(3) Top Cover
(4) Governor Connecting Rod
(5) Rack Pin
(6) Service Jig
(7) Lock Nut
S-63
ENGINE
(Refer to "5. SPECIAL
(8) Start Spring
(9) Sliding Point between Governor Fork
Lever and Governor Connecting Rod
A : 27.95 to 28.05 mm
(1.100 to 1.104 in.)
(To be continued)
W1069371
KiSC issued 06, 2020 A