07-E3B SERIES, WSM
Replacing Valve Bridge Shaft (for V2607-DI-E3B / V2607-DI-T-
E3B)(If necessary)
1. Remove the used valve bridge shaft (1).
2. Clean the valve bridge shaft mounting hole.
3. Apply the liquid seal (Three Bond 1386B or equivalent) to the tip
of the valve bridge shaft when installing shaft at the position
shown in figure (a).
4. Using valve bridge shaft replacing tool (3), press in the new shaft.
(Refer to "5. SPECIAL TOOLS" at "GENERAL" section.)
(1) Valve Bridge Shaft
(2) Coolant Passage
(3) Valve Bridge Shaft Replacing Tool
S-89
ENGINE
A : Intake Side
B : Exhaust Side
C : 31.30 to 31.70 mm (1.233 to 1.248
in.)
(a) Shaft Hole (Through To The
Coolant Passage)
(b) Shaft Hole (Not Through To The
Coolant Passage)
W1283273
KiSC issued 06, 2020 A