External Components - Kubota WSM 07-E3B Series Workshop Manual

07-E3B SERIES, WSM

(2) External Components

CAUTION
• While the engine is operating and or just after it stops, the turbocharger is hot, be careful not to touch the
turbocharger.
NOTE

• When detaching and attaching the turbocharger assembly, be very careful not to allow dust, dirt and other
foreign matter in the oil pipes.
• When the turbocharger assembly has been replace, pour fresh engine oil through the oil filler port of the
turbocharger.
• Before starting the engine, make sure that air cleaner is in position.
Air Cleaner, Muffler and Others
1. Remove the air cleaner and muffler.
2. Remove the fan (6), fan belt (5), cover (4), fuel filter cartridge (3),
fuel tubes (2), alternator (7) and starter (1).
(When reassembling)
• Check to see that there are no cracks on the belt surface.
• Mount the check valve with the  mark toward the tank.
IMPORTANT

• After reassembling the fan belt (5), be sure to adjust the fan
belt tension.
• Do not confuse the direction of the fan (6). Attach the fan (6)
with its marking facing frontward (toward the radiator).
(1) Starter
(2) Fuel Tube
(3) Fuel Filter Cartridge
(4) Cover
Oil Pipe and Intake Hose
1. Remove the joint bolt (1), bolt (3) and clamp band (4).
2. Disconnect the oil pipe 1 (2) and oil pipe 2 (5).
3. Remove the intake hose (6) and breather hose (7).
(When reassembling)
• Pour fresh engine oil through the oil filler port of the turbocharger.
• Replace the gasket with new one.
• Be careful not to allow dust, dirt and other foreign matters in the
oil pipes (2) / (5).
NOTE

• Tape or plug all openings to prevent foreign matters from
damaging the oil cavities in the turbocharger.
(1) Joint Bolt
(2) Oil Pipe 1
(3) Bolt
(4) Clamp Band
S-41
ENGINE
(5) Fan Belt
(6) Fan
(7) Alternator
W1049622
(5) Oil Pipe 2
(6) Intake Hose
(7) Breather Hose
W1025983
KiSC issued 06, 2020 A