Epson AcuLaser CX37DN Series Reference Manual page 175

SNMP
Item
SNMP SNMP
SNMP v1/v2c(IP)
SNMP v3(IP)
SNMP v1(IPX)
UDP Port
SNMP v1/ Read Community
v2c(IP) Name
Write
Write Community
Name
Description
If Enable is selected, SNMP is enabled.
Choices: Enable, Disable
Default: Enable
Configuration Menu Equivalent:
UTILITY - ADMIN. MANAGEMENT - NETWORK SETTING - SNMP
If Enable is selected, SNMP v1/v2c(IP) is enabled.
Choices: Enable, Disable
Default: Enable
If Enable is selected, SNMP v3(IP) is enabled.
Choices: Enable, Disable
Default: Enable
If Enable is selected, SNMP v1(IPX) is enabled.
Choices: Enable, Disable
Default: Enable
Note:
In order for this parameter to be available, NetWare Print in the Network -
NetWare page must be set to Enable.
Specifies the UDP port number.
Range: 1 - 65535
Default: 161
Note:
The numbers 427 and 500 cannot be specified.
Specifies the community name to be used for scanning.
Range: 1 to 15 bytes
Default: public
If Enable is selected, Write is enabled.
Choices: Enable, Disable
Default: Enable
Specifies the community name to be used for reading and writing.
Range: 1 to 15 bytes
Default: private
Epson AcuLaser CX37 Series
Using Web-Based EpsonNet Config
Reference Guide
175