Setting Up The Glasses - Christie Mirage SST-6P User Manual

4. Connect the RF transmitter(s) into the female mini-DIN3 connectors on the Christie View
cable.
5. Enable HFR:
a) Select MENU > Configuration > Input Settings > High Frame Rate.
b) To change to 2K resolution for HFR, select Enable.
c) At the confirmation prompt, select Enable.
The projector reboots and the High Frame Rate button changes to Disable.
Issuing the (OTR <0 | 1>) serial command for the Griffyn Series and Mirage SST also
toggles between the 4K and 2K resolutions.
6. Turn on the projector.
7. From the display panel, select Input Selection > Port Configuration and select one of the
following inputs: Four-port, 4 Viewer 2D or Four-Port, 2 Viewer 3D.
The port type is displayed in the preview screen of the display panel. All the transmitters
should be emitting a red light indicating they are on.

Setting up the glasses

Follow these steps to set up the XPAND Vision glasses to use with Christie View.
If using the XPAND Vision glasses for the first time, they must be paired with the RF emitter(s). If the
glasses have already been paired, skip to step 7.
1. Connect the first RF emitter to the mini-DIN3 connector on the Christie View cable labeled A.
Ensure only one emitter is connected to the Christie View cable.
2. Turn on the glasses by pressing the button on the inside of the frame once.
A red LED illuminates indicating the glasses are turned on.
3. Press and hold the button on the inside of the frame for at least one second.
The LED starts blinking at a rate of one blink every two seconds. After the glasses have
successfully paired with the RF emitter, the LED blinks six times.
4. For each pair of glasses needing to be paired to the connected RF emitter, repeat steps 2 to 3.
5. When all glasses for view A have been paired, disconnect the RF emitter for view A from the
Christie View cable.
Christie recommends the emitter(s) and glasses are labeled for their respective view to avoid
confusion during and after setup.
6. Repeat steps 1 to 5 connecting each RF emitter to the cable in descending order (B, C, and
then D).
Up to four emitters can be connected.
7. Turn on each pair of glasses by pressing the button on the inside of the frame once.
A red LED illuminates indicating the glasses are turned on. The glasses default to Four-port, 2
Viewer 3D mode. Each lens should be showing a different view.
8. If using Four-port, 4 Viewer 2D mode, double-press the button on the inside of the glasses
frame.
The LED blinks once. The same view should now be visible through both lenses.
The glasses are turned off automatically when the projector is powered off or if the input on the
projector is changed to a non-Christie View mode. Christie recommends ensuring the glasses are
Mirage SST User Guide
020-102993-06 Rev. 1 (10-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Setting up Christie View
57