3. Turn on the laser illumination source: On the laser illumination source, rotate the main AC
lockout/switch (A) to the on position and rotate the Power key (B) clockwise to the on position.
•
Local operation and the J33 terminal block 1 installed— Rotate the main AC lockout/switch
(A) to the ON position and rotate the Power key (B) clockwise to the ON position.
•
Remote operation and the J33 terminal block 2 installed—Rotate the main AC lockout/
switch (A) to the ON position and rotate the Power key (B) counter clockwise to the REM
(remote) position. From the automation device, turn on the laser illumination source (by
closing circuits 8/9 from the J33 wire).
The Interlock status indicator (C) on the laser illumination source turns yellow.
4. If the breaker is off, on the projector beside the AC inlet, move the AC breaker/switch to the
on position.
The projector boots into standby mode after approximately 30 seconds.
5. Once the projector is in standby, on the projector keypad or the projector remote, press and
hold the power
Mirage SST User Guide
020-102993-06 Rev. 1 (10-2021)
Copyright
©
2021 Christie Digital Systems USA, Inc. All rights reserved.
button until you hear a beep.
Operating the projector
20