Christie Mirage SST-6P User Manual page 60

Solution: Adjust the frame delay by selecting MENU > Image Settings > Advanced Image
Settings > Frame Delay.
Multiple views being observed when wearing the glasses
There is a potential for views other than your own to be visible based on brightness and content. This
is referred to as ghosting.
Solution: Try to display content close to the same brightness for all views being used. This will help
mitigate any ghosting that may occur.
The glasses are turning on and then off again after a few seconds
If the glasses cannot find an RF signal from an emitter within a few seconds, they turn off again.
Solution:
1. Make sure the projector is in Christie View mode.
2. Make sure the Christie View cable is seated correctly on the projector and the RF emitter(s)
are seated correctly for each Mini-DIN3 connector on the cable.
3. The glasses may need to be paired again with an RF emitter.
The glasses are not turning on
The battery level for that pair of glasses may be depleted.
Solution: Charge the glasses using a micro USB cable.
The LED on the glasses is blinking every few seconds
The battery level for that pair of glasses is getting low.
Solution: Charge the glasses using a micro USB cable.
Content is being projected as black on the screen
The glasses are turned on and functioning, a Christie View mode is selected, and the content preview
can be seen on the projector side panel display; however, content does not appear on the screen.
Solution:
1. Make sure the projector is set to 2K output resolution—2048x1080 (Griffyn Series and Mirage
SST)/1920x1080 (Christie M 4K RGB Series)—by selecting MENU > Status >
Configuration > 3. Output Resolution.
2. If the projector is configured to 4K output resolution (4096 x 2160):
a. Select MENU > Configuration > Input Settings > High Frame Rate.
b. To change to 2K resolution for HFR, select Enable.
c. At the confirmation prompt, select Enable.
The projector reboots and the High Frame Rate button changes to Disable.
Issuing the (OTR <0 | 1>) serial command also toggles between the 4K and 2K
resolutions.
Mirage SST User Guide
020-102993-06 Rev. 1 (10-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Setting up Christie View
60