Enabling A Specific Test Pattern Color; Selecting An Engine Test Pattern; Viewing Mirage Sst Status; Running The Mirage Sst Interrogator - Christie Mirage SST-6P User Manual

Enabling a specific test pattern color

You can enable a specific test pattern color to eliminate one or more colors to help with certain
diagnostics and setups, such as overlaying one image on top of another from stacked projectors.
1. From the side panel home page, use the arrows to select Test Pattern.
You can also select the test patterns from MENU > Test Pattern.
2. Select the Flat White test pattern.
3. To confirm your selection, select Enter.
4. On the IR remote keypad, press Func+6+<0 to 7>.
Where <0 to 7> represents a specific color.

Selecting an engine test pattern

Several engine test patterns are available to assist with the calibration and internal optical alignments
of the projector and to diagnose any issues that may occur.
1. Select MENU > Admin > Diagnostics > Test Pattern > Engine Test Patterns.
2. Scroll through the list of test patterns.
3. Select the required test pattern.
4. To confirm your selection, select Enter.
5. To disable the engine test patterns, select MENU > Admin > Diagnostics > Test Pattern >
Engine Test Patterns > Off.
6. To disable the engine test patterns, select MENU > Admin > Service > Engine Test
Patterns > Off.

Viewing Mirage SST status

Alarms contain information about the values of the items operating in normal range, warnings, and
errors that can be reported by the status system of Mirage SST.
1. From the display panel, select Status.
You can also view the statuses from MENU > STATUS.
2. Scroll to the status category you want to view and select it.

Running the Mirage SST interrogator

The interrogator captures diagnostic information Christie personnel uses to help diagnose and correct
any issues.
1. If saving the interrogator file to a USB flash drive on the projector, insert a USB flash drive in
the USB port on Mirage SST.
The USB flash drive must be formatted using the FAT 32 file system.
2. Select MENU > Admin > Interrogator.
3. Select Run.
• If on the projector, the interrogator file is stored at the root directory on the USB flash
drive.
Mirage SST User Guide
020-102993-06 Rev. 1 (10-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Diagnostic tools
66