Christie Mirage SST-6P User Manual page 18

9. On the projector beside the AC inlet, move the AC breaker/switch to the ON position.
The projector boots into standby mode after approximately 30 seconds. If the projector is
properly connected, the light on the back of the projector should be yellow.
10. Once the projector is in standby, on the projector keypad or the projector remote, press and
hold the power
The projector can also be turned on using the web user interface. After a few seconds, the
projector moves to the on state, causing the yellow light on the laser illumination source to
turn off. The laser is ready to be turned on but no illumination occurs until the green button is
pressed and the lasers have warmed up.
11. Turn on the lasers:
• Local operation and the J33 terminal block 1 installed— On the laser illumination source,
press the green Start button (D). This illuminates the green (button) light and the yellow
light goes out.
• Remote operation and the J33 terminal block 2 installed—From the automation device,
turn on the lasers with a 500ms contact closure of circuits 21/22 on the J33 wire. This
illuminates the green (button) light and the yellow light goes out.
Mirage SST User Guide
020-102993-06 Rev. 1 (10-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
button until you hear a beep.
Operating the projector
18