Christie Mirage SST-6P User Manual page 42

7. Select MENU > Configuration > Horizontal 1D Color Uniformity > Color Uniformity
Mode.
8. To disable color uniformity, select Color Uniformity Off.
9. Select Enter.
10. Select Color Correction Mode > Max Drives and to confirm your selection, select Enter.
11. Select Show Color Pattern > Auto and to confirm your selection, select Enter.
12. Record the x, y, and RGB luminance values for the center point.
a) Point the spectroradiometer at point 5 (middle square).
b) Click the X value.
c) Record the x value from the spectroradiometer in the projector user interface.
d) Click the Y value.
e) Record the y value from the spectroradiometer.
f) Click on the Red luminance setting.
The display changes to the appropriate color.
g) Record the luminance value from the spectroradiometer.
h) Click on the Green luminance setting.
The display changes to the appropriate color.
i) Record the luminance value from the spectroradiometer.
j) Click on the Blue luminance setting.
The display changes to the appropriate color.
k) Record the luminance value from the spectroradiometer.
13. Record the luminance values for the remaining four points (2—inside left, middle square; 15—
far left, middle square; 8—inside right, middle square; and 16—far right, middle square)
a) Point the spectroradiometer at a point.
b) Click on the Red luminance setting.
The display changes to the appropriate color.
c) Record the luminance value from the spectroradiometer in the projector user interface.
d) Click on the Green luminance setting.
The display changes to the appropriate color.
e) Record the luminance value from the spectroradiometer.
f) Click on the Blue luminance setting.
The display changes to the appropriate color.
g) Record the luminance value from the spectroradiometer.
Mirage SST User Guide
020-102993-06 Rev. 1 (10-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Configuring system settings
42