Dsa Emulex Adapter Test Results; Test Results For The Dsa Emulex Adapter Test - Lenovo System x3850 X6 Installation And Service Manual

Complete the following steps:
1. If the system has stopped responding, turn off and restart the system and then run the test again.
2. Make sure that the DSA Diagnostic code is at the latest level.
3. Run the test again.
4. Check system firmware level and upgrade if necessary. The installed firmware level can be found
in the DSA Diagnostic Event Log within the Firmware/VPD section for this component.
5. Run the test again.
6. If the system has stopped responding, turn off and restart the system and then run the test again.
7. If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service
Guide" for the next corrective action.
Related links
–
Lenovo Support website
–
Latest level of DSA

DSA Emulex adapter test results

The following messages are generated when you run the Emulex adapter test.

Test results for the DSA Emulex adapter test

The following messages can result when you run the DSA Emulex adapter test.
• 516-000-000 : ELXUCNA: NIC MAC LoopBackTest Passed
The test passed.
Recoverable
No
Severity
Event
Serviceable
No
Automatically notify support
No
Related links
–
Lenovo Support website
–
Latest level of DSA
• 516-001-000 : ELXUCNA: NIC PHY LoopBackTest Passed
The test passed.
Recoverable
No
Severity
Event
Serviceable
No
Automatically notify support
No
Appendix B. DSA diagnostic test results
365