Lenovo 5457 Installation And Service Manual page 221

Figure 118. Simple-swap hard disk drive removal for 4U server model with non-hot-swap power supplies
5. If you are instructed to return the drive assembly, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Replacing a simple-swap hard disk drive
This procedure applies only to 4U server models with non-hot-swap power supplies.
The 4U server model with non-hot-swap power supplies supports up to four 3.5-inch simple-swap SATA
hard disk drives, which are accessible from the front of the server.
Note: Only 3TB or below hard disk drive options are supported by the 4U server model with non-hot-swap
power supplies.
You must disconnect all power from the server before you remove or install simple-swap drives. Before you
install a simple-swap SATA hard disk drive, read the following information:
Install the drives starting from the top bay to the bottom bay (bay 3, 4, 5, and then 6). The following tables list
the IDs of the hard disk drives:
Table 34. IDs of simple-swap drives
Drive bay
3
4
5
6
• The simple-swap SATA hard disk drives connect to the SATA 0 through SATA 3 connectors on the system
board as follows:
HDD ID
0
1
2
3
.
Chapter 6 Removing and replacing components
209