Lenovo 5457 Installation And Service Manual page 258

Front USB connector
assembly
Spring clips
Figure 171. Front USB connector assembly installation for 5U server model with hot-swap power supplies (1)
4. Place the bottom edge of the housing into the bottom of the opening in the chassis; then, tilt the top of
the housing into position until it clicks into place.
Figure 172. Front USB connector assembly installation for 5U server model with hot-swap power supplies (2)
5. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
6. Reroute and connect the front USB cable to the front USB connector on the system board (see
"System-board internal connectors" on page 27
Note: Remember to route the cabling through the cable clips.
Lenovo System x3100 M5 Installation and Service Guide
246
Front USB housing
Front USB housing
for the location of the front USB connector).